$5.50

Embed Unicorn Horn Mold

The Unicorn Horn embed Mold is a MUST have to get on board with the unicorn trend. This swirled horn can be mica painted in magical colours and placed on top of soap, soap cupcakes and bath bombs!

Material: Food Grade PETG Plastic

Product Information:

Average Bar Weight: 0.30 oz.

Bar Dimensions: 2.875" x 1" x 0.625"

Max Pour Temp: 135ºF

Common Uses:
Melt & Pour Soap. Cold Process Soap. Lotion Bars.

Dimensions:
2.875" x 1" x 0.625"

10 caities

Points of Interest:
Manufacturer: Life Of The Party
Country of Origin: United States
Soap is easiest to release 12-24 hours after cooling.

Embeds are small molded pieces of wax or soap that are added to a larger candle or soap in order to ACCESSORIZE the already fabulous product that you make! Embed molds allow you to great CRAZY CREATIVE when making your handcrafted projects! We love that! The crazier the better.

 


Directions:

Cold Process Soap: Coat your mold with cooking spray or line with plastic. Wait 24 hours after pouring into mold by turning the mold over onto a clean surface. Gently push the back of the mold until the soap begins to release, then pull the soap out of the mold with a gloved hand. Allow your soap to cure for 4-8 weeks. Note that some Cold Process soap recipes may require a week to harden enough to remove from the mold. If this is the case with your recipe, we recommend adding sodium lactate to your recipe to assist with creating a harder bar quicker. Placing the soap in the mold for several hours to enhance release while frozen.

Melt & Pour Soap: Pour the melted soap at a temperature no hotter than 135ºF into the mold. Allow to cool until the soap has hardened. Remove the soap from the mold and wrap the soap immediately after unmolding. For easier unmolding, place into freezer for 30 minutes, and then immerse bottom of the mold in hot water for a few moments. Do not use cooking spray to coat mold before pouring in your soap mixture.

Lotion Bars: Pour your melted lotion bar mixture into the mold cavities at a temperature no hotter than 135ºF. Then allow the mixture to solidify. After your mixture has solidified, flip the mold over onto a clean surface. Gently push the back of the mold until the lotion bar begins to release then pull the bar out of the mold.

Care: Wash in warm, sudsy water. Avoid using a dishwasher as it can lead to your molds warping or make them brittle.